Description
Product Overview
Advanced Bridge Valve includes the following:
- 1 – Bridge Valve
- 2 – Custom Angle Stops
- 2 – Custom High Volume Supply Lines
Specifications
Pump Technical Data:
| Item Weight: | 2.4 ounces |
| Dimensions: | 6″ x 2″ x 1″ |
| Material: | Plastic |
| Thread size: | 1/2″ MIP |
Installation (scroll down for written instructions)
[one_half]
[/one_half][one_half_last][/one_half_last]Advanced Bridge Valve™ Installation
Location:
The Advanced Bridge Valve should be installed under the kitchen or bathroom sink at the farthest fixture from the water heater. Branched plumbing systems will need a Advanced Bridge Valve at the end of each line. Additional Advanced Bridge Valves are available at www.FasterHotWater.com.
Note: Do not use Teflon tape or pipe dope on Advanced Bridge Valve connections.
Advanced Bridge Valve Installation
New Angle Stop Installation:
- Turn off water to the house and drain the water from the pipes.
- Turn off both the hot and cold angle stops (valves) below the sink.
- Disconnect existing hot and cold water supply lines from the angle stops and replace angle stops with with new angle stops.
- Attach new stainless steel advanced 1/2″ x 1/2″ supply lines to nipples.
- Attach other end of advanced supply lines to the appropriate “Cold Water In” and “Hot Water In” ports of the Advanced Bridge Valve. Tighten finger tight plus a quarter turn with a wrench. Do not over tighten.
- Attach standard 1/2″ x 1/2″ standard supply lines to the appropriate “Cold Water Out” and “Hot Water Out” ports of the Advanced Bridge Valve. Tighten finger tight plus a quarter turn with a wrench. Do not over tighten.
- Attach other end of standard supply lines to the faucet. Tighten finger tight plus a quarter turn with a wrench. Do not over tighten.
- Leave angle stops in the off position and turn the house water back on. Check for leaks.
- Open both the hot water and cold water angle stops and check for leaks.
Advanced Bridge Valve™ Operation
The following steps will determine if the Advanced Bridge Valve is operating correctly.
- Close the cold water angle stop below the sink.
- Quickly turn the hot water faucet on and then off to activate the pump.
- Open the cold water faucet.
- Water should flow from the faucet until warm water (95°F) reaches the Advanced Bridge Valve. The flow should gradually decrease until no water is coming from the faucet at which time the Advanced Bridge Valve has closed.
